|
WLA-5000AP
New Firmware
Notice:
These firmwares can only be used on AirLive WLA-5000AP with its 32MB
DRAM capacity. Using the firmware on other AP can cause permanent
damage.
Please do not Power Off or touch the Web UI screen while
firmware is upgrading!
Before wait for the firmware upgrade completed message!
Version No:
Client Mode: v1.04e01
AP Mode:
v1.09e01
Release Note:
=============================
AP Firmware:
1. Add Tx Power EIRP Adjustment.
2. Add ACK Calculator
3. Add SNMP back to firmware
Client Mode Firmware:
1. Add RSSI in the Site Survey page
2. Add ACK Calculator
3. Add TX Power Regulation
4. Add SNMP back to firmware
Recommend Tx Power Settings for Antennas*
|
Antenna
|
Setting** |
|
WAE-5023PA(23dBi Patch) |
MAX-14 |
|
WAE-5018PA(18dBi Patch) |
MAX-10 |
|
WAE-5014PA(14dBi patch) |
MAX-6 |
*The recommend settings when your country's
maximum allowed AP+Antenna output power is 30dBm
****
(Output Power + Antenna Gain) minus (Cable & Connector loss)
should be
less or equal
to the legal limit.
Therefore, if you know your
(Cable & Connector loss), you can re-adjust
the settings accordingly.
=======================================
Measured Output Power for EIRP Adjustment
| TX
Power Settings |
Measured Output Power(dbm)* |
Max. Recommended Antenna Gain (dbi)** |
| MAX |
17.36 |
12 |
| MAX-1 |
17.1 |
12 |
| MAX-2 |
17.1 |
12 |
| MAX-3 |
17.1 |
12 |
| MAX-4 |
16.7 |
13 |
| MAX-5 |
15.5 |
14 |
| MAX-6 |
14.5 |
15 |
| MAX-7 |
13.9 |
16 |
| MAX-8 |
12.8 |
17 |
| MAX-9 |
11.8 |
18 |
|
MAX-10 |
10.8 |
19 |
|
MAX-11 |
9.9 |
20 |
|
MAX-12 |
8.6 |
21 |
|
MAX-13 |
7.5 |
22 |
|
MAX-14 |
6.4 |
23 |
*Measured at 54Mbps, error +/- 2dB, the real result depends on connector
and cable used in
actual installation.
**The recommend settings when your country's maximum allowed AP+Antenna
output power is 30dBm
***
(Output Power + Antenna Gain) minus (Cable & Connector loss)
should be
less or equal
to the legal limit.
Therefore, if you know your
(Cable & Connector loss), you can re-adjust
the settings accordingly.
|
