AP_v1.08e08
client_v1.03e11

Notice: These firmwares can only be used on AirLive WLA-5000AP only.  
        Using the firmware on other AP can cause permanent damage.

Release Note
=============================
AP Firmware:
1. Add Tx Power EIRP Adjustment.
2. Add ACK Calculator


Client Mode Firmware:
1. Add RSSI in the Site Survey page
2. Add ACK Calculator
3. Add TX Power Regulation

================================
Recommend Tx Power Settings for Antennas*

Antenna                     Setting
------------------------------------
WAE-5023PA(23dBi Patch)     MAX-14
WAE-5018PA(18dBi Patch)     MAX-10
WAE-5014PA(14dBi patch)     MAX-6


*The recommend settings when your country's 
maximum allowed AP+Antenna output power is 30dBm

=======================================

Measured Output Power for EIRP Adjustment

Settings      Measured Output Power*    Max.Recommended Antenna Gain**
----------------------------------------------------------------------------------------------------
MAX             17.36 dBm                             12 dBi	
MAX-1          17.1  dBm                              12 dBi 
MAX-2          17.1  dBm                              12 dBi
MAX-3          17.1  dBm                              12 dBi
MAX-4          16.7  dBm                              13 dBi
MAX-5          15.5  dBm                              14 dBi
MAX-6          14.5  dBm                              15 dBi
MAX-7          13.9  dBm                              16 dBi
MAX-8          12.8  dBm                              17 dBi
MAX-9          11.8  dBm                              18 dBi
MAX-10         10.8  dBm                              19 dBi
MAX-11          9.9  dBm                              20 dBi
MAX-12          8.6  dBm                              21 dBi
MAX-13          7.5  dBm                              22 dBi
MAX-14          6.4  dBm                              23 dBi

*Measured at 54Mbps, error +/- 2dB, the real result depends on connector and cable used in
actual installation.

**The recommend settings when your country's maximum allowed AP+Antenna output power is 30dBm

*** ((Output Power + Antenna Gain) minus (Cable & Connector loss)) should be <= the legal limit.
Therefore, if you know your (Cable & Connector loss), you can re-adjust the settings accordingly.